Hi!
I’m having some troubles updating my Mavo Edge 8K. I updated successfully from 6715 to 6745 then from 6745 to 7029 but the thing is I did not understand how to perform the “second updating” gafpa gear advices in its instructions for the Kinemon 5U. After the second updating and rebooting, I could not have the screen to turn on and it actually scared me. The camera seemed to be working very well (i could change settings) but the screen would not turn on, just the LED on the monitor flickering in RED, even after waiting more than 30 minutes and taking in and out the monitor cable. Finally I shut down the camera pushing on the power button and rebooted it and everything is fine since then.
But I’m still wondering if I did it all good anyway. I reset the settings as indicated but could not perform a black balance too. When I do (powering the camera with the menu button), the cursor goes back to cancel and the menu freezes (I cannot move the joystick). I can quit by pushing the menu button but after waiting more than 10 minutes, there is no message indicating that the procedure is done.
Can you help me with that ?
I wanted to test the efficiency mode for the production house I’m working with but cannot find the Compression setting in the 7.029 version.
Best regards,
Nicolas